Boating Boating  

Boat Paint

Boating

Bilge Pumps
Bimini Tops
Boat Anchors
Boat Insurance
Boat Ladders
Boat Loans
Boat Maintenance
Boat Motors
Boat Paint
Boat Prices
Boat Propellers
Boat Repair
Boat Safety
Boat Seats
Boat Steering
Boat Trailers
Boating
Buying a Boat
Cleaning
Corrosion
Inboard Engines
Life Vests
Marinas
Marine Stereos
Mold and Mildew
Navigation
Oil
Outboard Motors
Selling a Boat
Stern Drives
Stringers
Swim Platforms
Transom
Trim
Trolling Motors
Twin Engines
VHF Radios
Waxing Your Boat
Winches/Windlasses
Winterizing Your Boat
Wiring
<< Results 1 - 30    Results 61 - 86 >> 


Related Topics On Bottom Paint

  1. 1976 Fiberform, What model and what's it worth?
    ...faded as well as the bottom paint needs replaced...
  2. Another transom repair question...where to cut?
    ...batches from the cut off bottom of a plastic coke bottle... ...running out of the bottom. It was hotter epoxy...
  3. Wood Boat Hull Finish
    ...screwed into the transom bottom and sealed all edges...
  4. Need info on Seaway 17 boat
    ...I am doing over the bottom. I am sanded it and...
  5. Old boat new again?
    ...primered and painted the bottom. I... ...beautifully. I only did the bottom because if it looked...
  6. Osmosis (i think) Problems with my boat.
    ...forming all over the bottom. I can't push them... ...the very tip of the bottom there are 2 bubbles...
  7. Winter Storage
    ...Gallma, how did you bottom cleaning project turn...
  8. Composite transom...composite stringers...what about the floor?
    ...luan. Epoxy coat the bottom, epoxy the the 2nd...
  9. Mildew
    ...solution? next is the bottom paint, it was started... ..., any suggestions on bottom paint?... ...excellent Q & A section on bottom paints. I am assuming...
  10. Which is better......
    ...other marina paints the bottom and keeps it in the... ...have power washers and bottom paint to help keep the bottom clean. And then there...
  11. G3 (looks good to me)
    ...Tracker has a flat bottom hull while the G3 has... ...better than a flat bottom and provide a smoother...
  12. Floor/Foam replacement
    ...There was a hole in the bottom of my boat, and water...
  13. Leaving boat in the water
    ...do is apply a "GOOD BOTTOM PAINT", I suggest an... ...marine stores.Clean the bottom properly, and go for... ...and outdrive. the bottom paint goes on the bottom of the boat, not on... ...River Rat all the way. Bottom paint is a pain in... ...once a month and wash bottom (and fill the tank...
  14. Fish finder transducer........Help
    ...to epoxy this to the bottom of my boat while I...
  15. Barnicles baby barnicles
    ...Salt Water) without bottom paint for 3 weeks cycles... ...purchase is anti-fouling bottom wax. They sell this...
  16. Transom Question
    ...hole, tape off the bottom hole and your done..........
  17. How to prevent exterior damage??
    ...Also if it's a vee bottom ... the 'keel guard... ...epoxy them to the chine bottom on both sides.. at...
  18. Boat Pox - Blisters on Hull
    ...and had the marina bottom scub the un-painted... .... You can have the bottom re-gelcoated. This... ...blisters with special bottom paints (rea... ...a finish (abative) bottom pai... ...would highly recommend bottom paint for any boat... ...the water without a 'bottom paint' just givin'...
  19. Plywood hull vs. planks
    ...use good materials. Bottom painting is an annual...
  20. Salt Water
    ...followed by a good coat of bottom paint. If its not too...
  21. Gel Coat?
    ...I have a 73 Kona flatbottom. The original gel coat...
  22. Resin as glue
    ...gunkish mess in the bottom of my stringer holes...
  23. Soft Deck
    ...This would leave the bottom layer of glass in tact... ...plywood core, leaving the bottom layer. Remove all... ...glass on top of the bottom layer, making sure... ...careful with it, sand the bottom put a layer of glass...
  24. 79 walkaround grady white. stay away? or buy
    ...in the middle at the bottom where most patches...
  25. Tough stains
    ...Does your boat have no bottom paint, no boot stripe...
  26. Waxing a boat?
    ...has ribs along the bottom of the hull ,made of...
  27. JB and others with Montauk info!
    ...small holes at the bottom outside of the transom...
  28. Has quality changed?
    ...of all.. but still bottom line is money.. ya...
  29. Boat Lift
    ...painting my new boat bottom and getting one. I... ...itself just in reduced bottom maintenance and the...
  30. Stringer replacement. Replace the entire stringer or patch?
    ...bulheads out. The very bottom of the stringers (approx... ...Ok, I had the same bottom 3" rotten in 2 of the... ...couple spot along the bottom where the roven seprated...


If you would like to post your own question for the experts just click on the Boating Forums tab at the top of the page!

Disclaimer: This content is provided for the education and benefit of all boating enthusiasts.
We cannot, however, take responsibility for individual postings, nor can we verify the accuracy of any posting.
Please use any information provided from individuals with great care and read applicable outboard manual safety instructions.
Also, if you determine that a posting is inaccurate or offensive in any manner, please email us.

E-Mail this page to someone.

Home | Boats | Outboard Motors | Boat Dealers
Boat Prices | Boat Repair | Boat and Outboard Forum Directory | Marine Engines | Boat Covers
Propellers | Terms of Use | Privacy Practices | Legal Notices |

1-800-869-1686 (Toll Free)
001-801-571-0071 (International Calls)
Copyright © 1999-2009 iboats, inc. All rights reserved.