|
Related Topics On Fiberglass and Stringers
- Used boat buying advice
...and check the wood/fiberglass underneath for soft...
- Good book or video of fiberglass repair?
...for a good book on fiberglass repair and construction... ...shell out my dough! 1. Fiberglass repair and co... ...by Jack Wiley. 2. Fiberglass boat repair manual...
- Soft Spots?
...decks? I know they use fiberglass stringers. Any advice...
- Rotary or Drill saws for deck cutting?
...save the inner transom glass, (matting & resin over...
- Hull repair
...peeled off all the inner glass and took a putty knife... ...question is; Can I just glass the new stringers to... ...lay in new lathes and glass them down like the...
- Transom repair advice needed
...hull. I cut out the fiberglass skin of the transom... ...go right through the fiberglass -- just enough to countersink... ...edges and the sides (fiberglass skin) of the boat with... ...wrap the edges of the glass skin (transom edges) with glass tape, particularly... ...like my boat), you can glass it in. With epoxy and glass cloth, you should get...
- Chaparral Sunesta or Regal Destiny?
...floor/stringers and the glass is in good nick.. and...
- Here are some comments on Seacast..
...saving the inner Transom fiberglass? forgitaboutit, In... ...single layer or two of glass and resin. The time... ...remove the outer Hull glass, why ruin the looks... ...wood and preserve the glass, It should be the first... ...of saving the inner glass, as it is only for... ...tools required for fiberglass and WOOD bonding, In...
- Floor rot
...with epoxy and then glassed back in with fiberglass mat and resin.... ...by the top layer of glass on the floor and open... ...floor boards and no glass. T... ...hull of that boat was glassed and there was a lot... ...eventually epoxy and glass the edges of the floor... ...dry out where as the fiberglass traps the water....
- Replace transom...do it yourselfer?
...the wood out, cos the fiberglass is nearly 1cm thick...
- Replacing flooring.....Questions?
...I have a 17' Arrowglass Tri Hull, which I am...
- How much resin would you need for this...
...much epoxy resin and fiberglass would a person use... ...run out of resin and glass! H.... ...Homerr, I am re-glassing 18ft Mitchell, Including... ...gal. Decided when glassing in stringers to glass inside of hull to provide... ...plywood with a layer of glass in between each layer...
- Opinion on foam core
...about finished with re-glassing the area where my fuel... ...plywood pads to the floor glass with 3M 5200 and mounted... ...through the exposed fiberglass fibers. This is just...
- Help! My new(old )boat is rotted
...tank, they were just glassed over. Someon told me that when you glass over wood, there need... ...and expand, cracking fiberglass in the process. If...
- Starcraft Islanders
...little ruffer than glass, but also eaiser to...
- Transom on 16 ft tidecraft
...transoms and stringers in fiberglass boats. It can also...
- Aluminum or glass?
...floors and stringers in glass boats may rot, too....
- MFG Runabout
...like it alot, my firsg glass boat, did you know...
- Angler boats - any good, issues?
...stringers encapsulated in fiberglass, however I'm not sure...
- Chainsaw? YES!
...nylons to remove the fiberglass. But I would suggest...
- How can I make the hull stronger?
...removing the floor and glassing in additional stringers...
- Used chriscraft
...sometimes thru the fiberglass coating. A core sample...
- Made my own filler
...was a combination of fiberglass, gelcoat, wood and...
- Transom Rot/Floor Rot
...seacast... get a book on fiberglass boat repairs, there...
- Is there anything Positive with a Bayliner Boat
...it seep through the glass or does it come from... ...does a marginal job of fiberglass coating everything...
- Another transom repair question...where to cut?
...me. Now, did you use fiberglass mat or cloth? ! assume by 3/4 ox glass you are talking about...
- 1984 Arrow Glass center console
...an '85 (I think) 18' Arrowglass Coho Center Console...
- Positive floatation
...hard is it to make a glass boat have positive...
- Git Rot
...the wood with new and glassing the crap out of it....
- New guy here, questions about cheap old boat that I just bought.
...they be bad? Does the fiberglass develo... ...I've never done any fiberglass repair, so if I really... ...stringers are wood fiberglassed to the hull. On some boats, the fiberglass didn't even cover the...
|
|
