|
Related Topics On Fiberglass and Stringers
- Osmosis (i think) Problems with my boat.
...sanded the hull the fiberglass became porous. This...
- First boat, need advice
...properly encapsulated in glass) will have issues....
- Late discovery on my Bayliner
...when I found shoddy glasswork on the stringers below... ...with aluminum then reglassed the entire thing, but...
- Plywood covered with fibreglass boats
...has been used in f-glass boat construction for...
- Soft Deck, 1 year 4 mo later
...posts on replacing fibreglass and foam, here is a... ...remove transom, grind glass down to original hull...
- Anyone remember Glassmaster boats?
...and information on Glassmaster boats; that is if anyone... ...boat is a 1973 17 foot Glassmaster V-hull with a closed... ...Assmast..., huh, that is Glassmaster boats....
- Dissolving and Resolving Waterlogged Foam
...make of boat has all glass stringers, only wood...
- Would you recommend Starcraft Aluminum boats?
...me are better than Fiberglass or wood....
- Flooring replacement?
...cutting,fitting and glassing. A good carpenter can... ...the tools,wood,and glass to do it. Tools being...
- Transom HELP
...professional do the actual glasswork, but find a good glass-person first, and consult...
- ID this boat? (52kb pic inside)
...built by "Rainbow" Glass Products of Tualatin...
- Trophy Boats???
...Much better built. All glass stringers. I looked...
- Center Console Conversion Project Boat
...use 3/4 plywood and fiberglass over it? I'm trying...
- Rotted floor-89 Bayliner/Capri
.... stringers keep the fibreglass rigid and if they are...
- 1989 Bayliner
...this wood is. Also the fiberglass was applied using a... ...were stingy with the glass on the stringers ad...
- Floor/Foam replacement
...have. This is how the Fiberglass shop did it. Hope this... ...fit two small fiber glass boats with my own money... ...did the stringers and glassed both sides of a new... ...only $200. Another glass runabout, this one...
- Bryant boats/wood-free construction ?
...problems with rot in glass boats. I am wondering...
- My little 16 ft center console
...micro-ballons & milled fiberglass powder.. everything... ...hull 350 lbs. hull glassed with 7.5 oz cloth with... ...epoxy..the floor is glass but the inside sides...
- Looking at a 20' Crestliner Nordic
...eaiser to trailer than glass. Since they are lighter...
- Transom Question
.... I have owned many fiberglass boats and most had...
- Hrydo Glass boat rotted Floor
...everyone, Have hrydo glass boat with a rotted floor had to remove fiberglass that was on plywood... ...ScottRock, My Hydro Glass may be built different... ...bow and stren is all fiberglass mold wood ended there...
- Molasses leaking from pinhole in bottom
...8 inches thick with fiberglass on both sides, so you...
- Bayliner Capris: Opinions please???
...floor rot, thin, porous fiberglass letting water at untreated... ...Addmittedly, the finish glass (bilge-side) is hairy,and glass-shy.But it is thick...
- Replacing Transom
...floor seams were not fiberglassed, the foam was not completly... ...bottom hull were fiber glassed together was between... ..., and prybar to cut fiberglass flotaion foam boxes... ...transom. Cut inner fiberglass and braces from front... ...all rotten ant the glass is about all holding them. Well the glass and foam. The foam...
- Four Winns or Rinker
.... Four Winns is all fiberglass. Rinker is encapsulated... ...feeling when people read fiberglass stringers they assume...
- 86 Bayliner capri
...replaced. Original fiberglass does not fully encapsulate... ...Very poor layup,with foberglass "fur" everwhere below...
- Cutout for transom, Help!
...the transom before I glass, any help would be...
- Epoxy resin coverage?
...800 sq feet of 17/08 glass in it and have not... ..., gas tank pads and glassing the gunwales to the... ...around with 4 layers of glass. Epoxy don't go far in the heavier glass like 17/08 which cured...
- Resin as glue
...stringers, and you can glass them in with no worries... ...the original stringer glass? They make nice guides... ...I'm waiting for the glass and resin to get here... ...The wood's here, the glass is on its way. Now... ...take the old stringer glass all the way to the...
- 79 walkaround grady white. stay away? or buy
...transom to see if the glass shows signs of repair... ...problem if you have a glass floor. Put your hands... ...than $1500. If it's a glass floor then removal...
|
|
